OPTIMUM
M A S C H I N E N - G E R M A N Y
Operation
Version 1.1.6 dated 2014-10-16
Page 82
Original operating instructions
F150
GB
6.13
Data interfaces and current collection
When connecting data interfaces make sure that the data cable runs to the interface of the con-
trolwithin shortest possible distance. The cable routing can be conducted along the measuring
system lines. However the cable in the switch cabinet must never be routed nearby the drive
apparatuses of the NC axis or the frequency converter itself. Errors occur during data transfer
due to electromagnetic radiation (EMC-problems).
The control is equipped with the following data interfaces. They are located laterally on the con-
trol panel of the CNC machine:
RJ45 plug- in connection
USB connection
Power connection (socket for current supply (230V) e.g. for a notebook)
Img.6-11: Data interfaces and current collection
Designation
Specification
Timer
Act Time
controlled by the timer
Interval Time
Motor
Current consumption
2.5 A
Phases
1
Power
12 W
Pump
max. delivery flow
130 cc/min
max. delivery pressure
15 kgf/cm²
Diameter pressure joint
6mm
Storage reservoir
Capacity
2.5 litres
Material
Resin
Oil viscosity
32-68 cSt@40°C
USB interface
Network connection
Socket for current collection
(230V) e.g. for a notebook
Warning!
Do not use any devices which
require more than 2 A current!
