OPTIMUM
M A S C H I N E N - G E R M A N Y
Operation
Version 1.1.6 dated 2014-10-16
Page 73
Original operating instructions
F150
GB
6.3
Switching on the CNC machine
When switching on the machine the integrated safety functions of the machine
"Safety Integrated" are checked and scanned. Please proceed in the following sequence:
Switch on the main switch.
"Lockable main switch“ on page 14
Please wait until the control is completely started.
Unlock the "Emergency-Stop buttons".
"EMERGENCY STOP push button“ on page 15
Press the push button "Drive control ON"
.
First press the push button "SPINDLE START"
and then the
push button "FEED START"
Acknowledge the upcoming error message by pressing the push button "RESET".
On the Display the message 700033 "Door check" is displayed. Open and close the door once
in order to perform a safety test. Therefore, perform the following steps.
Press the push button "Open - Close door"
Open and completely close the door.
After closing the door, press the push button "RESET"
Img.6-2:
Control panel
If possible, read the upcoming messages on the display, remove the error messages, such
as e.g. insufficient compressed air, insufficient coolant / lubricant.
and error messages“ on page 86
For the following working steps, please proceed as described in chapter 2 „Operation and
programming“ of the Siemens „SINUMERIK 828 D" Operation instructions.
INFORMATION
Your CNC machine is equipped with an absolute measuring system.
A travel to reference point after power on is not necessary.
1
2
3
4
5
4
4
2
3
1
5
