OPTIMUM
M A S C H I N E N - G E R M A N Y
Assembly and commissioning
Version 1.1.6 dated 2014-10-16
Page 47
Original operating instructions
F150
GB
Respect the environment when disposing of any lubricants and coolants. Follow the
manufacturer’s disposal instructions.
"Cooling lubricants and tanks“ on page 108
3.11
Refill central lubrication system
The CNC machine is equipped with a central lubrication system.
INFORMATION
The CNC-milling machine is delivered without lubricating oil.
Fill the tank with lubricating oil via the filler hole.
"Cooling lubricants“ on page 93
"Adjusting the amount of oil at the central lubrication“ on page 116
Img.3-32: Central lubrication system
3.11.1 Functional test and controls
Check the direction of rotation of the CNC machine. There must be a right-handed rotating
field. If the direction of rotation is wrong, exchange two of the three phase conductors. At
this, the correct direction of rotation only refers to the drive of the cooling lubricant pumps.
Proceeding to set the direction of rotation:
Change over to the TSM mode "M8" or press the key.......
Observe the arrow direction resp. the direction of rotation of the cooling lubricant pump.
Img.3-33: Arrow direction/direction of rotation of the cooling lubricant pump
If the coolant / lubricant pump turns anticlockwise it is necessary to switch off the machine
and to have two of three phases (e.g. L1 and L2) exchanged by an electrical specialist!
Check all oil levels and filling levels of lubricants in the reservoirs.
Perform a safety test.
Filler hole
Arrow direction/direction of rotation
