Optimum OPTimill F 150, Operating Manual

Page: 76 / 162

OPTIMUM
M A S C H I N E N - G E R M A N Y
Operation
Version 1.1.6 dated 2014-10-16 Page 76 Original operating instructions
F150 GB
6.7 Manual operation of the tool changer
6.7.1 Manual operation of the 16-type tool changer
The operator can manually travel the tool changer to the reference point

Press the key <JOG> and <REF.POINT> on the machine control panel in
order to access the mode "Reference point approach".

Press the key <MAG> and <+> in order to release the travelling of the
tool changer

Press the key <Turn MAG> and <+> or
<MAG> and <-> in order to turn the tool changer to the desired
direction.

Press the key <FEED START> on the control panel of the machine 3 times contin-
uously. The LED via the key <FEED START> starts flashing and the message
700095 *** Service mode*** is displayed. Then the system goes to the ATC serv-
ice mode.
When the system has accessed the ATC-Service mode and the Z-axis and the spindle are in
the tool changing position, the operator can manually operate the tool changer.

Press the key <Move MAG> and <+> or
<Move MAG> and <-> in order to move the tool changer to the
desired direction. The key <
+
> moves the tool changer to the tool
change position.
6.7.2 Manual operation of the 24-type tool changer
The operator can manually travel the tool changer to the reference point

Press the key <JOG> and <REF.POINT> on the machine control panel in
order to access the mode "Reference point approach".

Press the key <MAG> and <+> in order to release the travelling of the
tool changer

Press the key <Turn MAG> and <+> or
<MAG> and <-> in order to turn the tool changer to the desired
direction.

Press the key <FEED START> on the control panel of the machine 3 times contin-
uously. The LED via the key <FEED START> starts flashing and the message
700095 *** Service mode*** is displayed. Then the system goes to the ATC serv-
ice mode.
When the system has accessed the ATC-Service mode and the Z-axis and the spindle are in
the tool changing position, the operator can manually operate the tool changer.

Press the key <move MAG> and the tool changer moves down to the tool
change position.

The key <+> and <-> moves the double arm of the tool changer .
6.7.3 Quit the ATC-Service mode

Press the key <FEED START> or <FEED STOP> or <RESET> on the machine control
panel in order to quit the ATC-Service mode.
+
+
-
FEED
START
+
--
+
+
-
FEED
START
+
-