OPTIMUM
M A S C H I N E N - G E R M A N Y
Safety
Version 1.1.6 dated 2014-10-16
Page 17
Original operating instructions
F150
GB
1.10
Personal protective equipment
For certain work personal protective equipment is required.
Protect your face and eyes: Wear a safety helmet with facial protection when performing works
where your face and eyes are exposed to hazards.
Use protective gloves when handling pieces or tools with sharp edges.
Use safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the required personal protective equipment is available at
the work station.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illnesses. Clean it each
time after use and at least once a week.
1.11
Safety during operation
WARNING!
Before activating the CNC machine ensure that this will neither endanger other persons
nor cause damage to equipment.
Avoid any risky working practices:
The instructions mentioned in these operating instructions have to be strictly observed dur-
ing assembly, operation, maintenance and repair.
Do not work on the CNC machine, if your concentration is reduced, for example, because
you are taking medication.
Stay on the CNC machine until the program is termi-
nated.
The running program can be identified by means of
the signal lamp.
- Continuous light: Program runs.
- Flashing light: NC stop or program hold.
Img.1-3:
Signal lamp
Safely and firmly clamp the workpiece before switching on the CNC machine.
Never change the dosing of the coolant supply during operation.
Never open the sliding door of the separating protective unit when the CNC-program is run-
ning.
