Chapter 4
•
Replacing Hardware Components
182 Replacing Hardware Components
Replacing Hardware Components
Replacing a Board
The table below lists the board types, required board combinations and slots.
For instructions on installing and removing boards, refer to the next page.
Chassis Components
Description
MGW 1100 chassis
Accommodates one host controller, one
switch, a Windows Media Server board and 5
service boards with corresponding I/O boards.
Without Windows Media Server, you may
install 6 service boards with corresponding I/O
boards. Fans and power supplies are pre-
installed.
19” rack-mount chassis
Rack-mounts MGW 1100.
Host
MGCS-5500 Host Controller board (front)
MGCI-5500 Host I/O board (rear)
Control (front)
Control (rear)
Switch
MGSS-1100 Switch board (front)
Switch (front)
H.264 Encoder
MGES-5610 (front)
MGEI-5210A (rear) or
MGEI-5210D (rear)
3 - 8 (front)
3 - 8 (rear)
3 - 8 (rear)
MPEG Encoder
MGES-5200 (front)
MGEI-5210A (rear) or
MGEI-5210D (rear)
3 - 8 (front)
3 - 8 (rear)
3 - 8 (rear)
DVB Recaster
MGRS-5200 (front)
MGRI-5200 (rear)
3 - 8 (front)
3 - 8 (rear)
DVB Transrater
MGTR-5200 (front)
MGRI-5200 (rear)
3 - 8 (front)
3 - 8 (rear)
DVB Transcoder
MGES-5200 (front) or
MGES-5610 (front)
MGTI-5210 (rear)
3 - 8 (front)
3 - 8 (front)
3 - 8 (rear)
To remove boards:
The host controller and the switch are not hot swappable. Before removing
these boards, MGW 1100 must be switched off.
1.
If you remove a hot swappable board and MGW 1100 is running, slightly
push the red button of the right ejector/injector handle down. When the
Hot Swap LED turns blue, the board is ready to be removed.
2.
Use the 5
׳
100 Phillips screwdriver to loosen the screws on the left and the
right side of the relevant slot cover on MGW 1100’s front panel. Loosen
StockCheck.com