Chapter 1
•
Installing Hardware
Installing Hardware 29
screws only until you feel a click. If you unscrew any further, you will
not be able to open the injector/ejector handles.
2.
Push the red buttons on the ejector/injector handles at the same time and
open them; the respective slot cover unplugs.
3.
Remove the slot cover and insert the desired service board into the chosen
slot.
4.
Plug the service board into the bus connector and close the
ejector/injector handles; you hear a click and the Hot Swap LED turns
blue when the board has been properly inserted. The board must line up
with the chassis surface.
5.
Use the 5
׳
100 Phillips screwdriver to tighten the screws on the right and
the left side of the I/O board.
6.
Locate the corresponding I/O slots on the rear panel and follow steps 1 –
5 to install the I/O board.
Figure 4
:
Opening the Ejector/Injector Handle
Note
Make sure to cover all empty slots with slot covers.
To install boards while operating MGW 1100:
All boards except the host controller and the switch can be removed and
installed while MGW 1100 is operating.
1.
Use a 5
׳
100 Phillips screwdriver to loosen the screws on the right and the
left of the relevant slot cover on MGW 1100’s front panel. Loosen the
screws only until you feel a click. If you unscrew any further, you will
not be able to open the injector/ejector handles.
2.
Push the red buttons on the ejector/injector handles at the same time and
open them; the respective slot cover unplugs.
3.
Remove the slot cover and insert the desired service board into the chosen
slot.
StockCheck.com