Chapter 1
•
Connecting MGW x100
36 Connecting MGW x100
Note
y
SDI is available for encoders, if digital input is enabled for the associated encoder
service board (MGES-5200).
y
Cables must be purchased separately.
To connect audio sources to encoders:
y
Balanced/Unbalanced
: Use the desired MGI Analog Audio cable to
connect analog audio sources as follows:
y
Use the MGI Analog Audio Cable with XLR connectors (WCA5197) for
balanced sources or the MGI Analog Audio Cable with RCA connectors
(WCA5196) for unbalanced sources respectively.
y
Connect the DB-15 connector to the relevant audio connector (
Audio A
or
Audio B
for Encoder 1 or 2 respectively).
y
Connect the connectors labeled
Audio Right Ch. 1
and
Audio Left Ch. 1
to the desired audio source. Depending on the cable you use, these
connectors are either XLR female or RCA.
y
If you use a second audio source, connect the connectors labeled
Audio
Right Ch. 2
and
Audio Left Ch. 2
to that source.
Figure 5
:
MGI Analog Audio Cable with XLR Connectors (WCA5197
(
Figure 6
:
MGI Analog Audio Cable with RCA Connectors (WCA5196
(
y
AES3 (AES/EBU)
: Use the MGI Analog Audio cable with XLR
connectors (WCA5197) to connect balanced AES3 audio sources to the
relevant audio connector AES3 A or AES3 B as explained above.
StockCheck.com