Optibase MGW 1100, Manual, Page: 99 / 200

Chapter 2
•
Creating and Editing a Channel Profile
Creating and Editing a Channel Profile 93
y
If you add a hot stand-by channel to a DVB transcoding or a live encoding channel,
associated with an SDI source, connect the relevant source to a separate input
interface and not to the primary channel's I/O board's Loop connector.
Transcoder I/O boards are available with two DVB-ASI inputs or one DVB-ASI input
and one Loop connector.
For DVB Transcoding:
y Input Component.
Select a DVB I/O board from the list. DVB I/O
boards only appear in the list if a DVB Transcoder channel can be added.
Note
If the DVB Trancoding H264 option does not appear in the Channel Type drop down list,
ensure that the appropriate type was defined as described in Adding Channels (on page
90).
y
Process Component.
Displays the service board for re-encoding that
corresponds to the selected I/O board.
y Output Component
MGW x100 supports up to 8 UDP targets per host
controller unit for each encoded stream. To add a target, select the desired
option and click Add .
Setting Channel Parameters
y
After setting input, processing and output components (targets), click
Next
; channel parameters appear. Follow the instructions
below to set or change channel parameters.
If you added a Hot Stand-By Channel
y
Do not change channel parameters or targets if you are adding a hot
stand-by channel. Channel parameters and targets are synchronized with
the associated primary channel's parameters and targets.
SAP Service
By default the SAP check box is selected. To disable SAP service clear the
check box.
Input Parameters
y Live Encoding.
On the Parameters page, click
IO Parameters
; input parameters appear and can be set or changed.
y DVB Recasting and DVB Transrating.
On the Parameters page, in the
IP Input I/F
section, under
Programs
, click ; programs received
by the selected DVB-ASI Input interface are available and parameters can
be set or changed.
StockCheck.com