Chapter 1
•
Connecting MGW x100
Connecting MGW x100 37
Note
y
The additional BNC connector labeled LTC is not used at present.
y
Embedded audio is part of the SDI input and does not require connecting an audio
source.
y
AES/EBU is available for encoders, if digital input is enabled for the relevant encoder
service board (MGES-5200).
y
Cables must be purchased separately.
To connect sources to DVB Recasters and DVB Transraters:
y
Use BNC cables to connect DVB-ASI compliant sources to the ASI In
connectors. Connect the first source to the BNC connector labeled ASI 1
In, the second source to ASI 2 In and so on.
To connect sources to DVB Transcoders:
y
Use BNC cables to connect up to two DVB-ASI compliant sources to the
BNC connectors labeled ASI 1 In and ASI 2 In respectively.
To connect monitors for preview to DVB Transcoders:
y
Video
. Use a BNC cable to connect monitors with Composite input to the
BNC connectors labeled Video A and/or Video B.
When re-encoding content using Transcoder 1, connect to Video A.
When re-encoding content using Transcoder 2, connect to Video B.
y
Audio
. Use the MGI Decoder cable (WCA5199) to connect an
unbalanced audio monitor as follows:
y
Connect the DB-15 connector to the relevant audio connector (
Audio A
for
Transcoder 1
and/or
Audio B
for
Transcoder 2
respectively).
y
Connect the XLR male connectors
Audio Right Ch. 1
and
Audio Left
Ch. 1
to the desired monitor.
y
If you use a second audio monitor to preview re-encoded audio content,
connect the XLR male connectors
Audio Right Ch. 2
and
Audio Left Ch.
2
to that monitor.
Figure 7
:
MGI Analog Audio Cable with XLR Connectors (WCA5197
(
StockCheck.com