![background image](http://html.mh-extra.com/html/omron/zx-t/zx-t_operation-manual_1633402012.webp)
9
ZX-T
Operation Manual
Pr
ef
ac
e
P
rec
au
tio
n
s
f
o
r Co
rr
ect
U
s
e
PREFACE
■
Sensor Head
• The Sensor Head is a high-precision device. Do not drop it or otherwise expose it to
shock.
• Do not expose the plunger to forces exceeding the limits in the following diagram.
Doing so may damage the plunger.
• Take measurements within the range that does not set off the Pressing Force Alarm.
• Do not remove the rubber boot. Without the rubber boot, foreign matter may enter the
Sensor Head, possibly causing the Sensor Head to malfunction.
• Mount the Sensor Head and Preamplifier in the specified location and under the spec-
ified load. Excessive force during installation may damage the Sensor Head or
Preamplifier.
• Replace worn actuators.
Replacing Actuators, p. 113
• Do not use the Sensor to measure objects that are revolving or moving (i.e., dynamic
measurement).
• Do not use air pressure outside the rated range when using a vacuum retract (VR) or
air push (AP). The measured pressure will fluctuate due to the air pressure, so the air
pressure must be regulated. An air vacuum device and a solenoid are required (ZX-
TDS10T-V
@
only).
• Supply dry air with filtration of 5
µ
m max. (ZX-TDS10T-V
@
only).
• The ZX-TDS10T-L can be mounted only facing downward.
■
Warming Up
After turning ON the power, allow the Smart Sensor to warm up for 15 minutes mini-
mum prior to use. The circuitry is not stable immediately after turning the power ON,
and the values gradually change until the Sensor is completely warmed up.
■
Maintenance and Inspection
• Always turn OFF the power supply before adjusting or removing the Sensor Head.
• Do not use thinners, benzine, acetone, or kerosene to clean the Sensor Head or
Amplifier Unit.
30 N
30 N
1 N
0.15 N
•
m
Rubber boot
Actuator
Plunger
Summary of Contents for ZX-T -
