A-Tach # 50206
Designed for:
Buick Enclave 2018 - 20__
ST-1
A
-Tach
Mounts
NOTICE:
A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
For best results, hold the vehicle mount over the place where the mount attaches to the dash
BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed
BEFORE
a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING:
AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
mount will attach into the two seams illustrated
with the arrows in the photo.
(2) Insert the thin edge of the seam tool into the
lower seam under the padded portion of the dash
to open the seam a little.
(3) Remove the covering from the tape. Press the
thin lower edge of the mount all the way into the
seam next to the seam tool.
(4) Remove the seam tool and insert it into the
seam between the display and frame illustrated in
the photo.
See additional instructions on the back side.
