A-Tach # 50291
Designed for:
Lincoln MKX 2016 - 2018
Nautilus 2019 – 20__
ST-1
A
-Tach
Mounts
NOTICE:
A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
For best results, hold the vehicle mount over the place where the mount attaches to the dash
BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed
BEFORE
a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING:
AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
top edge of the mount will attach into the seam
illustrated with the arrows in the photo.
(2) The lower notched edge of the mount will press
onto the top frame of the center vents.
(3) Press the thin edge of the seam tool into the
seam illustrated in the photo above.
(4) Remove the covering from the tape. Press the
tape in the lower edge notch onto the top vent
frame.
See additional instructions on the back side.
