55
ZX-T
Operation Manual
Sec
tio
n 4
M
e
a
s
ur
in
g Thic
k
ne
s
s
Section 4
MAIN APPLICATIONS AND SETTING METHODS
Setting Thickness Values
Use the Zero Reset Function to set the Sensor Head position for when the reference
sample is in place. Use the CH2 Amplifier Unit to perform this setting.
Insert a reference sample with a known thickness (T).
Switch to FUN mode and set the thickness on the Zero Reset display ([ZRDSP]).
Set the offset value and then return to the RUN mode.
Press and hold the ENT Key for at least 1 s to reset to zero.
The relationship between the positions of the CH1 and CH2 Sensor Heads will be reg-
istered at the same timing that was used when the zero reset was executed. (The dis-
play value here is 1 mm.) Thickness is measured based on the relationship of the
Sensor Heads, and the measurement result is displayed on the CH2 Amplifier Unit.
Refer to
Section 5 Detailed Settings
for details on operation.
Using the Zero Reset Function, p. 92
T
CH1
CH2
FUN
Offset value setting
Example: T = 1 mm
CH1
CH2
RUN
Press for 1 s min.
Summary of Contents for ZX-T -
