Omron K6PM-TH, User Manual

Page: 44 / 198

2 Installation and Wiring
2 - 8 K6PM-TH Thermal Condition Monitoring Device User’s Manual (H231)
• Use the supplied magnet until the positioning is identified.
In the case of using the product permanently, be sure to mount it by screws according to the following
dimensions.
• When handling the mounting bracket, take care not to injure yourself on the corners and other parts
of the bracket.
*1. Fit the holes in the mounting bracket onto the protrusions on the case.
*2. 1/4-20 UNC mounting hole (nut not included)
• If the position and space for directly installing the infrared thermal sensor on the back surface of the
control panel door cannot be secured, examine whether or not it is possible to perform measurement
by installing the infrared thermal sensor on a commercially available pan head such as that shown
below, and adjusting the position.
Install the commercially available pan head, etc. at the back of the control panel door, or on the inter-
nal side surface of the control panel.
Installing the Infrared Thermal Sensor
When the mounting bracket is mounted horizontally
Back side
Side
Back side
25.1 mm
With mounting bracket attached
When the mounting bracket is mounted vertically
Mounting bracket
2 × 4-dia. hole
32 mm
*1
*1
Screw hole for fixing base
mounting bracket (for direct
sheet metal attachment)
Screw hole for fixing base
mounting bracket (for direct
sheet metal attachment)
*2
Insert M3 screws in the
holes of the mounting
bracket, and fix.
* Recommended tightening
torque is 0.5 to 0.6 N·m.
*2