Omron E5AZ, User Manual

Page: 179 / 208

156
Appendix A
Error Displays
When an error occurs, the error contents are shown on the No. 1 display.
This section describes how to check error codes on the display, and the actions to be taken to remedy the
problems.
Meaning
The input value has exceeded the control range. (See note.)
Note Control Range
Resistance thermometer, thermocouple input: Temperature setting lower limit
−
20
°
C to temperature
setting upper limit + 20
°
C
(Temperature setting lower limit
−
40
°
F to temperature
setting upper limit + 40
°
F)
ES1B input: Same as input indication range
Analog input
−
5% to +105% of scaling range
Action
Check the wiring of inputs for miswiring, disconnections, and short-circuits and check the input type.
If no abnormality is found in the wiring and input type, turn the power OFF then back ON again.
If the display remains the same, the Controller must be replaced. If the display is restored, then the probable
cause is electrical noise affecting the control system. Check for electrical noise.
Operation at Error
After an error occurs, the error is displayed and the alarm outputs function as if the upper limit has been
exceeded.
When the “input error output” parameter in the advanced function setting level is set to ON, the alarm 1 output
turns ON whenever an input error occurs.
An error message is displayed when the PV, PV/SP, or PV/MV is displayed.
Note When the manual MV is set, the control output corresponds to the set value.
Meaning
Though this is not an error, it is displayed if the process value exceeds the display range when the control
range is larger than the display range.
The display ranges are shown below (with decimal points omitted).
• When less than
−
1999
[[[[
• When more than 9999
]]]]
Input Error
s.err
Display Range Exceeded
[[[[
]]]]