![background image](http://html.mh-extra.com/html/omron/e5ak/e5ak_user-manual_742558163.webp)
APPENDIX
E5AK
A--12
PARAMETER OPERATIONS LIST
·
Switching to modes other than manual or protect mode is carried out by mode selection in the menu
display.
·
The figure below shows all parameters in the order that they are displayed. Some parameters are
not displayed depending on the protect mode setting and conditions of use.
A/M
A/M
A/M
A/M
A/M
+
+
+
1 second min.
Level 0 mode
Level 1 mode
Level 2 mode
Setup mode
Expansion
mode
Option mode
Calibration
mode
1 second min.
Manual mode
Protect mode
1 second min.
1 second min.
1 second min.
1 second min.
Parameters in a mode can be
switched by the
key. The param-
eter following the last parameter is the
top parameter.
1 second min.
Power ON
1 second min.
1 second min.
1 second min.
1 second min.
1 second min.
Level 0
Level 1
Level 2
PV/SP
AT Execute/Cancel
Remote/Local
Remote SP monitor
Set point 0
SP mode
Set point during SP ramp
Set point 1
SP ramp time unit
MV monitor (heat)
Set point 2
SP ramp set value
MV monitor (cool)
Set point 3
LBA detection time
Valve opening monitor
Alarm value 1
MV at stop
Run/Stop
Alarm value 2
MV at PV error
Alarm value 3
MV upper limit
Manual mode
Proportional band
MV lower limit
Integral time
MV change rate limit
Manual MV
Derivative time
Input digital filter
Cooling coefficient
Open/close hysteresis
Protect mode
Dead band
Alarm 1 hysteresis
Position--proportional dead band
Alarm 2 hysteresis
Security
Manual reset value
Alarm 3 hysteresis
[A/M] key protect
Hysteresis (heat)
Input shift upper limit
Hysteresis (cool)
Input shift lower limit
Control period (heat)
Control period (cool)
Heater current monitor
Heater burnout