CHAPTER 5 PARAMETERS
E5AK
5--32
·
The parameters in this mode can be used only when the “security” parameter (pro-
tect mode) is set to “0” and “1”.
·
This mode contains the parameters for setting expanded functions. These parame-
ters include parameters for setting ST (self-tuning), setting the SP setting limiter,
selecting advanced PID and ON/OFF control, specifying the standby sequence reset
method, and automatic return of display mode.
·
To select this mode when in the levels 0 to 2, setup, option and calibration modes,
press the
key for 1 second minimum. The display changes to the menu display.
If you select [
] using the
key then press the
key for 1 second mini-
mum, the controller enters the expansion mode.
·
To select parameters in this mode, press the
key. To change parameter settings,
use the
or
keys.
·
The following table shows the parameters supported in this mode and the page where
the parameter is described.
Symbol
Parameter Name
Page
Set point upper limit
5-33
Set point lower limit
5-33
PID / ON/OFF
5-33
ST
5-34
ST stable range
5-34
a
5-34
AT calculated gain
5-35
Standby sequence reset method
5-35
Automatic return of display mode
5-36
AT hysteresis
5-36
LBA detection width
5-36
Expansion Mode