Copyright 2010-2015 Obihai Technology, Inc.
137
IP Phone Settings
Settings are divided into the following groups:
•
Phone Settings
•
Line Keys
•
Programmable Keys
•
Sidecar 1 and Sidecar 2
Phone Settings
DigitMap and OutboundCallRoute
The
DigitMap
controls what number the user can dial and applies the given transformation to the dialed number. It
can refer to the
DigitMap
parameter values in other parameter groups for better readability and organization. The
OutboundCallRoute
determines which service to use based on the dialed number, after validation and
transformation by the
DigitMap
.
Primary Line
You can select the Primary Line for the Phone and for the AA, respectively, using the parameters
Phone
Settings
::
PrimaryLine
and
Auto Attendant
::
PrimaryLine
. The primary line is the default line to use when there is
no explicitly selected line and no line-selection prefix (i.e. line access code) has been dialed. For example, when going
off-hook to get Dialtone, the phone will try to allocate a call key that is bound to the primary line for the call, if one is
available.
You can make one of the SP Services, OBiTALK, OBiBluetooth, or TG1/TG2 as the Primary Line for outbound calls. The
Primary Line for the Phone and the Auto Attendant is configured separately. The list below summarizes the choices
available for selection as the primary line:
•
SP1 Service
•
SP2 Service
•
SP3 Service
•
SP4 Service
•
SP5 Service
•
SP6 Service
•
OBiTALK Service
•
OBiBluetooth
•
Trunk Group 1
•
Trunk Group 2
The user may select a specific Line to use when making a call explicitly by pressing a call key or line monitor key bound
to that line or a soft key corresponding to that line. The user may also dial a Line’s access code before the destination
number. The default service route access codes are defined as:
•
** 1 for SP1
•
** 2 for SP2
•
** 3 for SP3
•
** 4 for SP4
•
** 8 for OBiBluetooth
