NTT docomo FOMA N703iD, Manual

Page: 51 / 500

49 Getting Started
<Power ON/OFF>
Turning the FOMA Terminal On/Off
● When you start using the FOMA terminal for the first time or if it has been left unused for a long time, charge the battery.
Turning the FOMA terminal on
●
Before turning the FOMA terminal on, make sure that the FOMA card is inserted correctly.
1
y
(1 second or longer)
The standby screen or initial settings screen appears. If you have just attached the battery pack and you turn the
FOMA terminal back on immediately after turning it off, “WAIT A MINUTE” message may appear for a short time.
■ When “ ” appears
You are outside the FOMA service area or in a place where radio waves do not reach. Move to
a place where the radio reception level icon such as “
” appears. The reception level for the
FOMA terminal is displayed as follows:
■ When “PIN1 code entry set” is set to “ON”
The PIN1 code entry screen appears. → P.136
■ When “All reset total cost” is set to “ON”
The PIN2 code entry screen appears.
■ If the Initial setting screen appears
Specify the initial settings. → P.50
Turning the FOMA terminal off
1
y
(2 seconds or longer)
The shutdown screen appears and the power is turned off.
N
z
When you change the FOMA card (UIM), you have to enter the 4- to 8-digit security code after turning on the FOMA terminal. The
standby screen appears when the security code is successfully entered. When you enter wrong security code for 5 times, the FOMA
terminal turns off (however, you can turn on the FOMA terminal again).
N
z
Signal strength is not stable in calls while moving. Calls may end suddenly. Wherever possible, you should always ensure that “ ”
is displayed when using the FOMA terminal.
Standby
Strong Weak