Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2, Administration Manual

Page: 643 / 684

ZENworks Imaging Engine Commands 643
no
vd
ocx
(e
n)
7 Ja
nua
ry 201
0
img zenPartition operation
where operation is enable, disable, or remove.
Š
Enter
img
to display the ZENworks Imaging Engine menu, click Partitioning , then click
one of the following:
Disable ZENworks partition
Enable ZENworks partition
Remove ZENworks partition
2 Enter
lilo.s
to make this change effective.
IMPORTANT: If you remove an installed ZENworks partition, you must immediately restore a
base image with a valid non-LILO MBR (Master Boot Record). If you do not, the device cannot
boot properly.
E.8 Dump Mode (img dump)
Use the Dump mode to view information about the hard drives and partitions on the device.
1 Do one of the following:
Š
Enter
img
to display the ZENworks Imaging Engine menu, click System information , then
click Drive information .
Š
Enter the following:
img dump [geo]
where:
Examples:
E.9 Information Mode (img info)
Use the Information mode to view the following:
Š The data currently stored in the image-safe area on the device
Parameter Action
dump Lists the existing partitions on all local hard drives. For each partition, the
type, size, and slot number of the partition are given.
The ZENworks partition and Dell or Compaq configuration partitions are
not listed.
geo Displays additional information about the geometry (cylinders, heads, and
sectors) and capacity of each hard drive.
Example Explanation
img dump Lists the current partitions on all local writable devices.
img dump geo Lists all hard drives, their geometry and capacity, and the current
partitions on the writable devices.