Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2, Administration Manual

Page: 434 / 684

434 Novell ZENworks 7.3 Linux Management Administration Guide
no
vd
ocx
(e
n)
7 Ja
nua
ry 201
0
This bundle is not assigned to any device or group after it is created, unless you click Next instead of
Finish to make that assignment.
IMPORTANT: If this Preboot bundle has been created on a management device inside the firewall
and you are assigning it to a device outside the firewall, port 8089 must be open both ways
(PUBLIC -> PRIVATE, and PUBLIC <- PRIVATE).
When the Multicast bundle’s trigger event occurs (configured in Step 8 ), the Multicast session
begins.
Enabling a Multicast Session
A wizard allows you to cause each device assigned to the ZENworks Multicast bundle to be enabled
for receiving the bundle when it reboots, even if the configuration for the device is to “do nothing”
(see
Step 5 through Step 7 in Section 30.7, “Editing Preboot Services Work,” on page 463 ).
The wizard does not assign a bundle to any device, nor does it make it the effective bundle for any
device. It only sets up a device to do ZENworks Multicast Bundle work for its effective bundle the
next time it boots.
To enable a ZENworks Multicast bundle:
1
In the ZENworks Control Center, click the Bundles tab to display the Bundles page:
2
Select the check box next to a ZENworks Multicast bundle .
3 Click Actions > Enable multicast session to start the Enable Multicast Session Wizard: