Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2, Administration Manual

Page: 445 / 684

Using Preboot Services 445
no
vd
ocx
(e
n)
7 Ja
nua
ry 201
0
(Optional) Select one or both of the following options:
Š
Use the IP Address from Content in the Preboot Bundle Rather Than from the
Device’s Image Safe Data
Use this option if you have previously taken an image of the device and are using that
image with this Preboot bundle. This option causes the imaging process to write the
device’s IP address that is contained in this image to the Image Safe Data location on the
replacement hard drive.
Do not use this option if the image being used for this bundle was not previously made
from this device.
If you do not select this option, then:
Š If the device that this Preboot bundle is applied to is still using its primary hard drive
to boot from, the IP address in its Image Safe Data continues to be used.
or
Š
If the device that this Preboot bundle is applied to has been given a new hard drive to
boot from, but you do not have a previous image of the old hard drive, then the IP
address is assigned according to your ZENworks Management Zone configuration
for non-registered devices.
Š
Use the Identity Information from Content in the Preboot Bundle Rather Than from
the Device’s Image Safe Data
If you are using a previous image of this device, this option writes ZENworks Control
Center object identity information as contained in the image to the new hard drive’s Image
Safe Data location, which allows the device to retain its ZENworks Control Center object.
However, if the image contained in this bundle was not previously made from this device,
it receives the new ZENworks Control Center object that is defined in the image.
If you do not select this option and the device that this Preboot bundle is applied to has
been given a new hard drive to boot from, then a new ZENworks Control Center object is
created according to your ZENworks Management Zone configuration for non-registered
devices.
8 Click Next to display the Summary page.
9 Review the configuration, then click one of the following:
Back: Allows you to make changes after reviewing the summary.
Next: Allows you to perform the following tasks before creating the bundle:
Š
Specify device assignments for this bundle
Š
Specify groups for this bundle
Continue with Section 30.6, “Assigning Unassigned Preboot Bundles,” on page 461 to assign
the bundle and complete the wizard.
Finish: Creates the AutoYaST bundle as configured per the settings listed on this Summary
page.
This bundle is not assigned to any device or group after it is created, unless you click Next instead of
Finish to make that assignment.