Nordson Encore XL Powder, Manual

Page: 78 / 155

© 2021 Nordson Corporation
1607027-01
8-4 Repair
Latch Installation
(cont)
4. See Figure 8-4. If all latches have been removed from the hex shaft, push or pull on
the hex shaft (3) to center the lever (2) in the yoke (1) before you tighten the set screw
to secure the latch to the hex shaft.
5. After all latches have been re-installed, check the latch movement by extending and
retracting the clamping cylinder by hand. The pawl should move freely side-to-side
and not bind on the sides of the latch body when the latch is extended and retracted.
If the pawl binds against the sides of the body, loosen the four latch mounting screws,
then push outwards on the sides of the latch body while re-tightening the screws.
3 1
2
Gap should be equal both sides
Figure 8-4 Lever Position − Step 4
1. Yoke 2. Lever 3. Hex shaft