Nordson Encore XL Powder, Manual

Page: 76 / 155

© 2021 Nordson Corporation
1607027-01
8-2 Repair
Latch Pawl Replacement
See Figure 8-2. To remove a latch pawl from a latch:
1. Raise the lance assembly all the way up.
2.
Press the E-Stop button on the feed center control panel to shut off the power and air.
This relieves the air pressure and mechanically locks the lift cylinder in position.
3. Remove the hopper/box table from the enclosure:
a. Remove the nuts (2) from the isolation mounts (1).
b. If using a vibrator motor, loosen the motor cable cord grip and pull the cable slack
through the grip.
c. Lift the table up off the mounts and move it enough to gain access to the purge
manifold assembly.
1 2
3 4
Screw inside recess
Figure 8-2 Pawl Replacement
1. Isolation mount
2. Nut 3. Pawl mount 4. Pawl
4. Remove the Philips-head screw securing the pawl (4) to the pawl mount (3).
5.
Position the new pawl on the latch with the top surface of the pawl flush with the top
surface of the latch lever.
6. Secure the pawl to the latch with the screw. Tighten the screw securely.
7. Re-install the hopper/box table on the isolation mounts, and then, if used, pull the
vibrator motor cable back into the control cabinet. Leave enough slack in the cable to
avoid any strain on it, then tighten the cord grip.