Nordson Sealant Equipment PRO-METER V2K, Customer Product Manual, Page: 64 / 195

Removal and Installation
10-12
Part 7440274
2017 Nordson Corporation
Carriage
See Figures 10-20 and 10-21
Removal
WARNING:
Relieve system air pressure, material pressure, and disconnect power
prior to servicing Pro
− Meter V2K components. Refer to Maintenance,
Preparation For Maintenance And Service (page 8 − 3) for additional
information.
Allow only qualified personnel to perform the following tasks. Follow the
safety instructions in this document and all other related documentation.
Clean any material that has spilled. Be sure to follow all applicable
safety and environmental guidelines when cleaning spilled material.
Refer to Safety (page 1 − 1) for additional information.
1. Remove air actuator. Refer to Removal and Installation, Air Actuator
(page 10 − 2) for air actuator removal procedure.
2. Remove socket head cap screws and lock washers securing carriage
hard stop to the carriage.
3. Remove socket head cap screws (1) securing carriage (2) to slide
blocks (3). See Figure 10-20.
NOTE:
It is not necessary to remove the guide rod, limit switch mount, strike
screw, or strike stop to remove the carriage.
Supply shop air [80 − 100 psi (0.55 − 0.69 MPa, 5.52 − 6.89 bar)] to air
actuator and reposition carriage as required. Repositioning allows
access to carriage − to − slide block socket head cap screws. See Figure
10-21.
1
2
3
Figure 10-20 Carriage Removal From Slide Blocks