Disassembly and Assembly
11-1
Part 7440274
2017 Nordson Corporation
Section 11
Disassembly and Assembly
It is imperative to follow the safety instructions outlined in this manual. Refer
to
for additional information. Contact a Nordson Sealant
Equipment representative regarding these procedures, if necessary.
WARNING:
Safety glasses are to be worn at all times while installing, servicing,
operating, or observing equipment. The sudden release of air or fluid
can cause damage to eyes.
Allow only qualified personnel to perform the following tasks. Follow the
safety instructions in this document and all other related documentation.
Relieve system air pressure, material pressure, and disconnect power
prior to servicing Pro
−
Meter V2K components. Refer to
Preparation For Maintenance And Service (page 8
information.
Apply Loctite properly to fasteners. Refer to
for Loctite application information.
Clean any material that has spilled. Be sure to follow all applicable
safety and environmental guidelines when cleaning spilled material.
Refer to
WARNING:
Any material injected into flesh can cause severe injury or
death. Keep body parts away from material discharge ports. If injection
occurs, seek medical attention immediately.
WARNING:
Operating faulty electrostatic equipment is hazardous and can
cause electrocution, fire, or explosion. Make resistance checks part of your
periodic maintenance program. If you receive even a slight electrical shock
or notice static sparking or arcing, shut down all electrical or electrostatic
equipment immediately. Do not restart the equipment until the problem has
been identified and corrected.
CAUTION:
Relieve air and material pressure when equipment is not in use for
prolonged periods of time. Do not allow pressure to remain static when
equipment is idle as this may cause material to pack and harden.
Only apply removable thread locker and sealant as specified by the
procedures in this section.