Nordson Sealant Equipment PRO-METER V2K, Customer Product Manual, Page: 75 / 195

Removal and Installation
10-23
Part 7440274
2017 Nordson Corporation
Linear Speed Control (If Equipped)
See Figures 10-31 through 10-35
Removal
WARNING:
Relieve system air pressure, material pressure, and disconnect power
prior to servicing Pro
− Meter V2K components. Refer to Maintenance,
Preparation For Maintenance And Service (page 8 − 3) for additional
information.
Allow only qualified personnel to perform the following tasks. Follow the
safety instructions in this document and all other related documentation.
Clean any material that has spilled. Be sure to follow all applicable
safety and environmental guidelines when cleaning spilled material.
Refer to Safety (page 1 − 1) for additional information.
1. Remove the secondary cover (2) from the primary cover (1).
CAUTION: Utilize hand pressure to lift secondary cover from primary cover
Be sure not to damage secondary cover mounting tabs.
1
2
Figure 10-31 Secondary Cover Removal From Primary Cover
2. Remove gravity tank bracket (if equipped). Proceed as follows:
Remove gravity tanks. Refer to Removal and Installation, Gravity Tank
(page 10 − 16) for gravity tank removal procedure.
Remove socket head cap screws securing gravity tank bracket to air
actuator.