Nordson Sealant Equipment PRO-METER V2K, Customer Product Manual, Page: 82 / 195

Removal and Installation
10-30
Part 7440274
2017 Nordson Corporation
CAUTION:
Insert small pry bar, or equivalent tool, into machined recess to separate
metering cartridge assembly from metering cylinder housing. See Figure
10-40.
Be careful not to damage metering cartridge assembly or metering
cylinder housing.
Pry point
Figure 10-40 Metering Cartridge Assembly Pry Point
Installation
Installation of metering cartridge assembly is in the reverse order of
removal. Note the following:
Tighten metering cartridge assembly socket head cap screws to 13.5
N
m (10.0 ft − lb).
Hand tighten plug so that it is snug (if removed).
Hand tighten reducer so that it is snug (if removed).
Hand tighten discharge port fittings so that they are snug (if removed).
Install gravity tank bracket to air actuator socket head cap screws and
tighten to
Hand tighten mounting collar socket head cap screws to 7.9 N m (70.8
in. − lb).
Loosely install socket head screws securing primary cover to primary
cover bracket (LH/RH) and then tighten until they are snug.