Removal and Installation
10-37
Part 7440274
2017 Nordson Corporation
Installation
Installation of the pneumatic valve manifold is in the reverse order of
removal. Note the following.
Loosely install socket head cap screws (1) and nuts (3) securing
pneumatic valve manifold (2) to air valve control shelf (3) and then
tighten in a criss
−
cross pattern to 3.9 N
m (34.8 in.
−
lb).
Loosely install air valve control shelf bracket to strike end plate cap
screws and then tighten to 13.5 N
m (10.0 ft
−
lb).
Loosely install socket head screws securing primary cover to primary
cover bracket (LH/RH) and then tighten until they are snug.
Hand tighten green terminal block screws until they are snug.
CAUTION:
Do not kink or otherwise damage air lines and electrical wiring
harness.