Nibe SMO 10, Installation And Maintenance Instructions Manual, Page: 45 / 60

Service menus 43
SMO 10
Operating settings Settings additional heat
Menu 9.3.3 Extra Shunt Present
This menu is used to select On or Off depending on
whether you have shunt group 2 (accessories needed).
O f f
E x t r a S h u n t P r e s e n t
9 . 3 . 3
Menu 9.3.4 Room unit
Accessories are needed.
R o o m u n i t
9 . 3 . 4
Menu 9.3.2 Electric boiler
Additional heat mode is actuated when Yes is shown
on the display, otherwise No. When the additional
heat mode is activated, the immersion heater respec-
tive circulation pump cannot be blocked with the oper-
ating mode button.
N o
E l e c t r i c b o i l e r
9 . 3 . 2
S
S
S
Menu 9.3.0 Operating settings
Settings regarding supplementary heat, floor drying
and a return to the factory settings can be made on
the sub-menus in this menu.
O p e r a t i n g s e t t i n g s
9 . 3 . 0
Menu 9.3.1 Max Boilertemp.
The setting selected on the load monitor card (2) knob
(102) is shown here.
8 0 ° C
M a x . B o i l e r t e m p .
9 . 3 . 1
S
S
Menu 9.2.12 Return
Pressing the Enter button returns you to menu 9.2.0
R e t u r n
9 . 2 . 1 2
Menu 9.2.8 Oilburnertemp.
The oil boiler temperature is shown here in °C.
O i l b u r n e r t e m p .
9 . 2 . 8
S
Menu 9.2.9 Oil Starttemp.
Temperature setting that the oil boiler should have
before the shunt valve is permitted to open.
The value is adjustable between 10 and 65 °C.
5 5 ° C
O i l S t a r t t e m p .
9 . 2 . 9
S
Menu 9.2.10 Step up type
The max. elec. step during the first two hours after a
power failure is set here. The value is adjustable
between 0 and 7 steps.
2
S t e p u p t y p e
9 . 2 . 1 0
S
Menu 9.2.11 Step up type
The way in which the immersion heater is connected
is set here.
Can be set to either Binary or Linear.
B i n a r y
S t e p u p t y p e
9 . 2 . 1 1
S