Nibe SMO 10, Installation And Maintenance Instructions Manual, Page: 15 / 60

Electrical connection 13
SMO 10
SMO 10 must be installed via an isolator switch with a
minimum breaking gap of 3 mm.
Disconnect the control module before insulation test-
ing the house wiring.
Connection
NOTE!
Electrical installation and service must
be carried out under the supervision of
a qualified electrician. Electrical
installation and wiring must be carried
out in accordance with the stipulations
in force.
NOTE!
In order to prevent operating
disturbances, sensor cables and
modular cables should be kept separate
from the power cables when cable
routing.
NOTE!
Work behind screwed covers may only
be carried out under the supervision
of a qualified installation engineer.
LEK
Terminal block (11)
Terminal block (14)
Load monitor card (2)
Terminal block (4), communi-
cation FIGHTER 2010 / 2005