
Actions with operating disturbances
11
SMO 10
Alarm indications on the display
Supply sensor
This information is shown when a fault on the flow
temperature sensor has been registered. The alarm
may be due to a faulty sensors or broken sensor
cable. The information disappears once the fault has
been rectified and the alarm reset on menu 9.3.6.
Warmwater Alarm
This information is shown when a fault on the hot
water temperature sensor has been registered. The
alarm may be due to a faulty sensors or broken sensor
cable. The information disappears once the fault has
been rectified and the alarm reset on menu 9.3.6.
WARMWATER ALARM
1 . 0
S U P P L Y S E N S O R
1 . 0
Warmwater el.power
This information is shown when a fault on the immer-
sion heater temperature sensor has been registered.
The alarm may be due to a faulty sensors or broken
sensor cable. The information disappears once the
fault has been rectified and the alarm reset on menu
9.3.6.
WARMWATER EL.POWER
1 . 0
Miniature circuit breakers (7) are located on the under-
side of SMO 10. Normal mode on the miniature circuit
breakers is “
1
” (to the right).
Resetting the miniature circuit breakers
Summary of Contents for SMO 10
