NF WAVE FACTORY WF1967, Instruction Manual (Operations

Page: 305 / 330

17.7 Sweep Oscillation Mode
WF1967/WF1968 17-15
Common regardless of sweep type.
However, logarithmic can use only frequency sweep.
Sweep range setting Specify starting value and stop value, or center value and
span value
However, the center value is also a simple average of
starting value and stop value during frequency logarithmic
sweep.
Assigning a marker value to a center value is possible (the
other way around is also possible).
Setting range of Sweep Time 0.1ms to 10,000s (resolution 4 digits or 0.1ms)
Common regardless of sweep type.
Sweep mode Continuous, single, gated single (switch)
Common regardless of sweep type.
For gated single, it oscillates only during running sweep.
However, when the waveform is DC, gated single is not
available.
Operation Start, stop, hold, resume, starting value output and stop
value output.
Trigger source (used for single sweep and gated single sweep)
Internal, external input terminal (switch)
In addition, CH2 can select the same trigger source as
CH1.
Common regardless of sweep type.
Trigger delay setting is disabled.
Manual trigger available.
Internal trigger oscillator for sweep (used for single sweep and gated single sweep)
Period setting range 100.0µs to 10,000s (resolution 5 digits or 0.1µs)
Stop level setting (used for gated single sweep)
Function Specifies the signal level when gated single-sweep is
stopped.
Setting range -100.00% to +100.00% (amplitude full-scale reference
and resolution 0.01%) or off
When stop level is set to off, stops by set oscillation
start/stop phase.
Common regardless of sweep type
Remarks When the waveform is noise, oscillation start/stop phase is
invalid, stop level is always valid.
When the waveform is DC, oscillation start/stop phase is
invalid, stop level is invalid
For phase sweep, sweep starting value is oscillation start
phase and sweep stop value is oscillation stop phase
Oscillation stop unit when gated single Cycle, Half Cycle (switch)