NF WAVE FACTORY WF1967, Instruction Manual (Operations

Page: 135 / 330

4.8 Setting and Operation of Sweep
WF1967/WF1968 4-85
• Stop amplitude [Stop]
• Sweep time [Time]
Time to change from the starting amplitude to the stop amplitude.

P.4-74
• Sweep Mode [SwpMode]
Select from continuous, single, or gated single.

P.4-75
• Sweep function [SwpFctn]
Select from one-way, shuttle.

P.4-75
It is possible to set with center amplitude [Center], and span amplitude [Span], instead of start
amplitude, and stop amplitude.

P.4-74
When sweep mode is single or gated single, it is necessary to set the trigger condition [Trig].

P.4-77
Set the following items as needed:
• Marker amplitude [Marker] (second page of the setting screen)

P.4-79
• Stop level [StpLvl] (second page of the setting screen)

P.4-76
The setting used for gated single sweep only.
• Oscillation stop unit of the gated single sweep [OscStop] (second page of the setting screen)

P.4-76
The setting used for gated single sweep only.
• Synchronization/sub output selection [SubOut] (third page of the setting screen)

P.4-79
4.8.7 Setting DC Offset Sweep
For the sweep setting screen and the common operation method, please refer to P.4-71, P.4-74
a) DC offset sweep example
Examples of a continuous sweep and linear shuttle.
Shuttle sweep
b) To select DC offset sweep
c) Waveform or mode where DC offset sweep is unavailable
None. However, when DC is selected as a waveform, the DC level itself is swept. In addition, when
DC is selected as a waveform, gated single sweep cannot be performed.
Select [Offset] in the sweep type setting menu
When the oscillation mode [Mode] is set to
sweep oscillation mode [SWEEP], select
the sweep type [SwpType] on the second
page of the setting screen to display the
selection list. When the DC offset [Offset] is
pressed, DC offset sweep is set.
Sweep value
Start value
Sweep time Sweep time
Stop value
Output signal