NF WAVE FACTORY WF1967, Instruction Manual (Operations

Page: 72 / 330

4.3 Basic Settings and Operations
WF1967/WF1968
4-22
sequence start on/off settings for when the power is restored after being cut off.

P.4-24
•
REMOTE I/F select [Remote]
Selects GPIB and USB and set the GPIB address. Also displays the USB ID.

P.13-2
•
System Information [Information]
Displays the firmware version and last modified date.

P. 13-3
•
Channel Mode Settings [Channel Mode](WF1968 only)
Sets the type of operating mode when 2 channels are linked. Options include Independent

P.8-7, 2 phase

P.8-7, Constant frequency difference

P.8-9, Constant frequency ratio

P.8-11, Differential output
１

P.8-13, Differential output 2

P.8-14
•
2 Channels identical setting ON/OFF [Both](WF1968 only)
Sets whether the same settings are applied to both channels.

P.8-5
Use the arrow keys or modify knob to select the item and press ENTER to set or change each
item.
•
External 10MHz Frequency Reference ON/OFF [Ext Reference]
Sets permitted or forbidden for the external 10MHz frequency reference.

P.10-4
•
External 10MHz Frequency Reference state didplay [10MHz Ref In]
Displays whether the external 10MHz frequency reference signal is valid or not.

P.10-4
•
Frequency Reference Output ON/OFF[10MHz Ref Out]
Switches the 10MHz reference output terminal on or off

P. 9-4
•
Color and brightness [Display]
Sets the display backlighting.

P.13-2
•
Modify Direction Settings [Modify Direction]
Sets the direction of movement when the modify knob is turned.

P. 13-2
•
Sound ON/OFF [Sound]
Sets the operation sound.

P.13-3
•
Self Diagnostic [Self Check]
Performs an internal status check.

P. 13-3
•
Copy Parameters Between Channels [Parameter Copy](WF1968 only)
Copies the settings between channels.

P.8-3
Each item can also be set or changed by pressing the corresponding number [0]...[9] on the
numeric keypad. Use the Next soft-key to switch between the item numbers on the left and
right hand side.