New lift FST-2, Manual, Page: 121 / 194

5 Menu tree
5.4 MAIN MENU – Config
FST-2_HB.EN12/05
119
Weight sensor
Level–Empty
Level for the empty state when using an analogue weight
sensor. 000 .. 200 %
Weight sensor
Level–Full
Level for the full state when using an analogue weight sensor. 000 .. 200 %
Weight sensor
Level–OverL
Level for the overload state when using an analogue weight
sensor. 000 .. 200 %
Speech output
Activated
Activates control of a speech processor using an additional
SPK module (see “Speech output codes” on page 123). ON
OFF
Speech output
Output type
Coding of the SPK module’s output.
-
HEX: Binary code
-
1-of-N: Separate signal for each output
- GRAY: Gray code
See “Speech output codes” on page 123.
HEX
1-of-N
GRAY
Speech output
Speech codes
Speech codes
Allocation of the speech output code (see “Speech output
codes” on page 123). 0 .. 255
Project Config
Basis
Project specific parameters.
Project Config
LON Modules
Project specific parameters.
Hall Stations
Landing Call Enable
Delay when re-enabling landing calls after special drives. This
prevents immediate starting of the car, e.g. after switching off
inspection control. 0 .. 30 sec
Hall Stations
ADM-EAZ Coding
Position indicator code issued on ADM X3.
-
HEX: Binary code
-
1-of-N: Separate signal for each floor (only possible up to a
maximum of five floors)
-
GRAY: Gray code
The initial value for the bottom floor can be set in
Bottom
Flr. Hall
(see “Bottom Flr. Hall” on page 114).
HEX
GRAY
1-of-N
Hall Stations
Special display 0
Function of terminal 14 of the
ADM-S landing call module (the function of terminal 14 must
be set to “Soft-0” in the FST Editor).
0: No function
1: “Door open” display for revolving doors
2: Fireman mode active
3: Priority car or landing active
4: Fireman mode or fire signal active
5: Out-of-use display (only when the system is
shut down)
6: Priority car active 0 .. 255
Hall Stations
Special display 1
No function at present 0 .. 255
Menu item Description Setting range