New lift FST-2, Manual, Page: 128 / 194

5 Menu tree
5.4 MAIN MENU – Config
126
FST-2_HB.EN12/05
Floor
The “Lobby” floor is set in
Floor
.
Doors
The car doors to be opened on the “Lobby” floor are set in
Doors
.
V.I.P. mode The V.I.P. mode can be used the dedicate a car to VIPs. There are two
V.I.P modes:
- V.I.P. mode 1: Triggered by the LMS or a programmable input/output.
Sets all call calls to “dead man mode”.
- V.I.P. mode 2: Triggered by FPM input X4.34 (key switch in the car), has
the functions described below.
V.I.P. mode 2
- Triggered by an impulse on FPM input X4.34 (key switch or card
reader).
- All pending landing calls are deleted and landing control is blocked.
- Group operation: the lift is removed from the group and returns all
pending landing calls to the group controller.
- A car call must be placed within ten seconds of activation, otherwise the
lift will return to normal mode.
- All car calls already registered at the time of activation will be completed
as usual.
- In “multiple call” mode (see “Pin-34 Functn” on page 123), an unlimited
number of car calls can be placed. This way, the V.I.P. mode can be
extended as desired.
- In “single call” mode (see “Pin-34 Functn” on page 123), only one car
call can be placed. Further car calls can only be placed after re-
activating FPM input X4.34.