New lift FST-2, Manual, Page: 137 / 194

5 Menu tree
5.6 MAIN MENUE – Calls
FST-2_HB.EN12/05
135
Special call mode Pending calls can be processed in three different ways:
Lift-Boy mode The Lift-Boy mode requires a lift boy to be present at all times. The mode
works as follows:
- The Lift-Boy mode can be activated permanently with parameter
Lift-
Boy mode
or temporarily with FPM input X4.34 (see “Pin-34 Functn”
on page 123).
- Landing calls are acknowledged but not processed automatically.
- Each acknowledged landing call will be confirmed on the car panel by
flashing of the corresponding car call and a short sound of the buzzer
(FPM output X4.38 “Display 2”).
- The lift boy processes landing calls one after the other by following the
flashing car calls.
Settings:
-
Pin-34 Functn
=
2
(see “Pin-34 Functn” on page 123) if Lift-Boy
mode should only be activated temporarily with a key switch.
-
Lift-Boy mode
=
ON
to activate Lift-Boy mode permanently.
-
Display 1
=
00000000
(see “Display 0 .. 2” on page 122)
-
Load-Sw.Disp
=
00000000
(see “Speech output codes” on
page 123)
Setting Method
Standard
Landing and car calls are collected.
Non-collective
-
Only one call at a time is accepted.
-
The car is reserved as long as it is moving or
a door is open.
-
If the car is reserved, landing calls are
blocked.
Single call mode
-
Only one call at a time is accepted.
-
The car is reserved as long as it is moving or
a door is open.
-
If the car is reserved, landing calls are
collected but not processed.
-
When the car is released, the oldest call will
be processed first.