New lift FST-2, Manual, Page: 160 / 194

6 Programmable inputs and outputs
158
FST-2_HB.EN12/05
To enable the parametrised flag, bit 0 must be set to “1” in parameter
MAIN
MENU - Configuration - I\O Configuration - I\O Flags
- Ctrl
, see “Setting flag control” on page 159!
Flag function Description Value
(hexadecimal)
Normal operation 00000001
Controller stopped Shutdown through FST menu 00000002
Emergency stop 00000004
Inspection mode 00000008
Auxiliary control 00000010
Runtime monitoring Motor monitoring has triggered
and shut down the FST-
Controller. 00000020
Fire signal 00000040
Fireman mode 00000080
Overload 00000100
Full load 00000200
Lift OFF 00000400
Priority car 00000800
Priority landing 00001000
Landing control OFF 00002000
Calibration / learn
drive Calibration or learn drive is
running. 00004000
Evacuation 00008000
not assigned 00010000
not assigned 00020000
not assigned 00040000
Data transmission A data file is transmitted. 00080000
Maintenance required A service counter (motor hours,
drives, door cycles) has reached
its limit. 00100000
Power supply too low The supply voltage is below the
minimum (+17V). 00200000
Homing Park drive to the lowest floor
(hydraulic lifts). 00400000
Park drive Park drive according to the set
program parameters. 00800000
Service The lift system is serviced,
function of the error storage is
suppressed. 01000000
Self test The FST performs a self test. 02000000
End switch test A test drive to the top and bottom
end limits is running. 04000000
User error 0 The user defined error no. 1 has
occurred (See “User error” on
page 161.). 08000000