New lift FST-2, Manual, Page: 47 / 194

4 Technical data
4.2 FST-2-Controller
FST-2_HB.EN12/05
45
In both cases, the controller must shut down with the following error
message:
DRM-MISSING ZONE
(see Installation & Commissioning
manual)
LEDs The LEDs listed in the following table are located to the right of relays FST
K20 .. K23.
Plug and terminal strip X1
LED Colou
r
State Description
LD17 K20 green on bypass door zone
LD18 K21 red on Enable door zone
LD19 K22 yellow on Encoder door zone A
LD20 K23 yellow on Encoder door zone B
FST-2:
X1
Power supply / messages
Inputs/outputs
1 +24V DC / 2A (supply voltage of FST-2)
2 0V / GND / 2A (supply voltage of FST-2)
3 +24V DC / 2A (supply voltage of FST-2)
4 Programmable input/output 0 (port-0)
5 Programmable input/output 1 (port-1)
6 Programmable input/output 2 (port-2)
7 Programmable input/output 3 (port-3)
8 Programmable input/output 4 (port-4)
9 Programmable input/output 5 (port-5)
10 Programmable input/output 6 (port-6)
11 Programmable input/output 7 (port-7)
12 0V / GND
13 Car Light OFF (KABL-AUS)
14 Landing calls OFF (AST-AUS)
15 0V / GND
16 Temperature monitoring machine compartment (MR-TEMP)
17 Overload (Überlast)
18 Full load (Vollast)
19 Brake monitoring brake A (UE-BREMSE_A)
20 Brake monitoring brake B (UE-BREMSE_B)
21 Drive monitoring (UE-ANTRIEB)
22 Motor monitoring (UE-MOTOR)
23 Standstill monitoring (UE-Schuetz)
24 +4V DC / 2A