New lift FST-2, Manual, Page: 12 / 194

3 FST-2-Controller user interface
3.1 LC-Display and messages
10
FST-2_HB.EN12/05
3.1 LC-Display and messages
The LC-Display consists of four lines A, B, C and D with 20 digits each.
After switching on and during normal operation, the FST-2-Controller
displays the main screen.
Main screen
Line C has a special status. In normal mode (after switching on), it displays
status messages (see “Status messages in line C” on page 13). When
switching with key combination
S
+
¥
+
¤
it displays diagnostic
messages, see “Diagnostic messages in line C” on page 14.
Also see “Keypad functions” on page 32.
Line A
Safety circuit messages
in Line A
A Maximum active state of the safety circuit
B Active state or error
C Status of the lift system / diagnostic message
D Data for current drive mode
SAFETY CCT CLOSED
>AX< ###@###
00 13:06:56
Display Description
SAFETY CCT CLOSED
The safety circuit is completely closed
(FST X14.1 & FST X14.2).
SFTY-CLOSED MISSING
The input “Safety circuit closed” has no power.
Possible reasons:
-
Terminal FST X14.1 has no power (normally
bridged with X14.2)
-
Relay K14 on the FST is faulty
DOOR LOCK B OPEN
The shaft door contact of door side B is
interrupted (FST X14.2 and X14.3).
DOOR LOCK A OPEN
The shaft door contact of door side A is
interrupted (FST X14.3 and X14.4).
DOOR A OPEN
The car door contact of door side A is
interrupted (FST X14.4 and X14.5).
DOOR B OPEN
The car door contact of door side B is
interrupted (FST X14.5 and X14.6).
DOOR C OPEN
The car door contact of door side C is
interrupted (FST X14.6 and X14.7).
MANUAL DOOR OPEN
A manual door contact is interrupted
(FST X14.6 and X14.7).
EMERGENCY END
SWITCH
The top emergency end switch of an hydraulic
lift is interrupted (FST X14.6 and X14.7).