New lift FST-2, Manual, Page: 16 / 194

3 FST-2-Controller user interface
3.1 LC-Display and messages
14
FST-2_HB.EN12/05
Diagnostic messages in line C Line C can be switched from status messages to diagnostic messages with
key combination
S
+
¥
+
¤
. Use key combinations
S
+
¥
and
S
+
¤
to
scroll through the diagnostic messages.
Status Display Description
Car doors
<A>
Door A completely open
>A<
Door A closed
<-A->
Door A is opening
->A<-
Door A is closing
<A*>
Photocell or reversing contact door A
active
<AX>
Door A is locked (test menu)
<AL>
Door is in loading mode (loading
button activated)
-A-
Door A is stopped
?A?
State of door A is unknown (check
door limit switches)
<-<>->
Door open button active
->><<-
Door close button active
Shaft positioning
Z
Zone message active
F
Zone message missing
-
Car is in levelled position
###@###
Car position relative to levelled
position (each pixel = 2.5 mm)
ö
Correction switch bottom KU active
ä
Correction switch top KO active
Car position
P=6200
Current position of the car relative to
levelled position of lowest landing in
[mm]
Levelling
Pd= -2
Current position of the car relative to
closest levelled position in [mm]
Car speed
V=1300
Current speed of the car in [mm/s]
Set / actual speed
@######V2
Comparison between set and actual
speed of the car. The left bar is a
graphic display of the relation
between actual speed and the set
speed on the right.
Motor hours
BS=4351
Operating hours of the drive
Drive counter
FZ=123456
Number of completed drives
Memory occupied
Rec: 45%
Memory occupied on the PC-Card
when recording