New lift FST-2, Manual, Page: 28 / 194

3 FST-2-Controller user interface
3.1 LC-Display and messages
26
FST-2_HB.EN12/05
PC-Card
PC:s0 m1 c0 f0 Mb005
State of pawl
device
ASV: 0000000 P=[00]
The state of the pawl device is coded as follows:
Code Description
s0
No PC-Card inserted
s1
PC-Card inserted – card type not detected
s2
PC-Card inserted – card type detected / card OK
s3
PC-Card inserted – card type not detected / error
m0
PC-Card memory type unknown
m1
Card type: static RAM
m2
Card type: flash memory
c0
CIS memory: no CIS found
c1
CIS status: CIS OK
f0
Flash type: PC-Card unknown / unusable
f1
Flash type: AMD A28F040 – 512kB memory module
f2
Flash type: INTEL I28f016 – 2MB memory module
Mb
Size of memory storage in 0.1 MB steps
Bit Setting Description
ASV: .......
0
(right)
active Pump for bolt control ON
1
active Valve “extend bolt” activated
2
active Valve “retract bolt” activated
3
active End switch “bolt extended” active
4
active End switch “bolt retracted” active
5
active Input “car bottomed” active
6
(left)
active Input “re-pumping” active
Digit Code Description
P=[..]
1 (right)
0
Standstill
1 (right)
1
Main contactors ON, waiting for star-delta start-up
1 (right)
2
Lift car (approx. 30mm / 1 3/16")
1 (right)
3
Motor run-on active
1 (right)
4
Waiting for bolts to extend or retract
1 (right)
5
Bolts extended or retracted completely
1 (right)
6
Waiting for input “car bottomed”
1 (right)
7
Delay after stop
2 (left)
0
No bolt movement
2 (left)
1
Bolts are retracting
2 (left)
2
Bolts are extending