Utility Commands
602
ProSafe Managed Switch
Note:
This command takes effect only once after it is executed and cannot
be saved across power cycles.
Format
ip address-conflict-detect run
Mode
show ip address-conflict
This command displays the status information corresponding to the last detected address
conflict.
Address
Conflict
Detection
Status
Last Conflicting
IP Address
Last Conflicting
MAC Address
Time Since
Conflict
Detected
clear ip address-conflict-detect
This command clears the detected address conflict status information.
Format
clear ip address-conflict-detect
Mode
Link Local Protocol Filtering Commands
Link Local Protocol Filtering (LLPF) allows the switch to filter out multiple proprietary protocol
PDUs, such as Port Aggregation Protocol (PAgP), if the problems occur with proprietary
protocols running on standards-based switches. If certain protocol PDUs cause unexpected
results, LLPF can be enabled to prevent those protocol PDUs from being processed by the
switch. These commands are not supported on M4100 switches.
llpf blockall
Use this command to block LLPF protocol(s) on a port. Use
blockall
to filter all PDUs with a
DMAC of 01:00:00:0C:CC:CX on the interface. Use
blockisdp
to filter the ISDP packets on
the interface. Use
blockvtp
to filter the VTP packets on the interface. Use
blockdtp
to filter
Global Config
Term
Definition
Identifies whether the switch has detected an address conflict on any IP address.
The IP Address that was last detected as conflicting on any interface.
The MAC Address of the conflicting host that was last detected on any interface.
The time in days, hours, minutes and seconds since the last address conflict was
detected.
Privileged EXEC
