Quality of Service (QoS) Commands
444
ProSafe Managed Switch
The last precedence applies to all non-TCP traffic. For example, in a 3-color system, four of
each parameter specified: green TCP, yellow TCP, red TCP, and non-TCP, respectively.
Format
random-detect queue-parms queue-id-1 [queue-id-2 … queue-id-n]
minthresh thresh-prec-1 … thresh-prec-n max-thresh thresh-prec-1 …
threshprec-n drop-probability prob-prec-1 … prob-prec-n
Modes
• Global Config
• Interface Config
no random-detect queue-parms
Use this command to set the WRED configuration back to the default.
Format
no random-detect queue-parms queue-id-1 [queue-id-2 … queue-id-n]
Modes
• Global Config
• Interface Config
traffic-shape
This command specifies the maximum transmission bandwidth limit for the interface as a
whole. Also known as rate shaping, traffic shaping has the effect of smoothing temporary
traffic bursts over time so that the transmitted traffic rate is bounded.
Format
traffic-shape <bw>
Modes
• Global Config
• Interface Config
no traffic-shape
This command restores the interface shaping rate to the default value.
Format
no traffic-shape
Modes
• Global Config
• Interface Config
show classofservice dot1p-mapping
This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes
for a specific interface. The
<unit/slot/port>
parameter is optional and is only valid on
platforms that support independent per-port class of service mappings. If specified, the
802.1p mapping table of the interface is displayed. If omitted, the most recent global
configuration settings are displayed. For more information, see
Voice VLAN Commands
on
page
62
.
Format
show classofservice dot1p-mapping [<unit/slot/port>]
Mode
Privileged EXEC
