NEC N8800-162F, User Manual

Page: 74 / 280

3-6 Linux Setup and Operation
4 Repair Mirroring Arrays (RAID1)
5 Delete Mirroring Arrays (RAID1)
6 Remove Disk Partitions (RAID1)
7 Make Striping Array (RAID1+0)
8 Delete Striping Array (RAID1+0)
c Configurations
q Quit
Command: 1 (Check if the disk specified is isolated from the RAID
configuration.)
[List RAID Arrays]
Name Partition
(Label) Status Member
=======================================================
< Mirroring Array (RAID1)>
md0 /boot ( - ) SIMPLEX (1)sda1
md1 swap ( - ) SIMPLEX (1)sda2
md2 / ( - ) SIMPLEX (1)sda3
md3 /var/crash ( - ) SIMPLEX (1)sda5
(After verifying the isolation of the specified disk from the
RAID configuration (verifying no partition of the specified disk
is in Member), replace the hard disk. Wait approximately five
minute before the system starts to resynchronize. If there is
no automatic synchronization, manually restore the disk with the
below procedure.)
Command action
1 List RAID Arrays
2 List Internal Disks
3 Make Mirroring Arrays (RAID1)
4 Repair Mirroring Arrays (RAID1)
5 Delete Mirroring Arrays (RAID1)
6 Remove Disk Partitions (RAID1)
7 Make Striping Array (RAID1+0)
8 Delete Striping Array (RAID1+0)
c Configurations
q Quit
Command: 2 (Check if the replaced disk is recognized by the
system.)
[List Internal Disks]
Slot Name [use] Informati
on
(Vendor/Model/Serial) path
============================================================
1
sda (sdq) [4] AAA/BBB/#CCC h5c0t12810
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9
sdi (sdr) [4] AAA/BBB/#CCC h6c0t12810
10 -
11 -