NEC N8800-162F, User Manual

Page: 78 / 280

3-10 Linux Setup and Operation
Configuring duplication
The following shows information on how to configure duplication by using the settings shown
below as an example.
<Configuration information>
Slot number: 3
SLAVE0 interface name: eth100100
SLAVE1 interface name: eth110100
IP address: 192.168.0.1
Subnet mask: 255.255.255.0
Default gateway: 192.168.0.1
IMPORTANT:
This must be operated by root user.
1.
Execute the following command. Configure network interfaces eth100100 and eth110100
that are corresponding to slot 3 as a coupled interfaces.
# vndctl add 3
2.
Execute the command below to configure the network settings (the parts with * are to be
specified by a user) on the combined interface that has been constructed. When you enter
default gateway, you can omit the process by pressing ENTER without specifying
anything.
# vndctl config 3
*Boot Protocol? [none/dhcp/bootp] none
*IP address? 192.168.0.1
*Netmask? 255.255.255.0
*Default gateway (IP)? 192.168.0.1
*Are you sure to set it? [y/n] y
DEVICE=bond2
ONBOOT=yes
BOOTPROTO=none
IPADDR=192.168.0.1
NETMASK=255.255.255.0
GATEWAY=192.168.0.1
3.
Execute the following command to activate the configured coupled-interfaces.
# vndctl up 3