NEC N8800-162F, User Manual

Page: 232 / 280

7-20 Troubleshooting
Problems with NEC EXPRESSBUILDER
When the server is not booted from the NEC EXPRESSBUILDER DVD, check the following:
†
Did you set the NEC EXPRESSBUILDER DVD during POST and restart the
server?
→
If you do not set the NEC EXPRESSBUILDER DVD during POST and restart the
server, an error message will appear or the OS will boot.
†
Is BIOS configuration correct?
→
The boot device order may be specified with the BIOS setup utility of the server.
Use the BIOS setup utility to change the boot device order to boot the system
from the optical disk drive first.
<Menu to check: [Boot]>
†
Is the connected Flash FDD or inserted floppy disk formatted?
→
Make sure that the Windows recognizes that the connected Flash FDD or inserted
floppy disk is formatted. If not, format it.
†
If [Os installation] is selected at Boot selection screen, following message is
displayed.
After this message appears, check the error and take the appropriate corrective action according to
the error codes listed in the table below.
Message Cause and Remedy
This EXPRESSBUILDER version
was not designed for this
computer. Insert the correct
version and click [OK].
(When you click [OK], the
computer reboots) This EXPRESSBUILDER version was not
designed for this server.
Execute the NEC EXPRESSBUILDER on
the compliant server.
EXPRESSBUILDER could not get
the hardware parameters written
in this motherboard.
This version is not designed for
this computer or the motherboard
may be broken. (When you click
[OK], the computer reboots)
The hardware parameters written
in this motherboard are incorrect.
This version is not designed for
this computer or the motherboard
may be broken.
(When this error occurs just after
changing the motherboard,
configure the hardware
information properly on the
[Maintenance Utility) This message is shown when such as
NEC EXPRESSBUILDER could not find
system-specific information because of
motherboard exchanged.