1. IML Error Message
Express5800/R120h-1M, R120h-2M Maintenance Guide
181
Chapter 3 Appendix
Class
Error code
Error message
Action
UEFI
226
Power Fault Detected - Embedded
Storage Controller %1.
Turn off the power on the unit, disconnect the
power cord, and check the installation of internal
storage controller %1. Wait 30 seconds, and then
restart it. If the problem persists, contact your
sales representative.
UEFI
227
Power Fault Detected - M.2 riser
Turn off the power on the unit, disconnect the
power cord, and check the installation of M.2 riser.
Wait 30 seconds, and then restart it. If the problem
persists, contact your sales representative.
UEFI
244
IMPORTANT: The device in PCIe
Slot %1 is SRIOV capable but is
installed in a slot that does NOT support
SRIOV.
When using the SRIOV, install an optional card in
the slot where the SRIOV is supported. If the
problem persists, contact your sales
representative.
UEFI
251
IMPORTANT: Switches SW1 and SW3
are ON. This is only used to recover %1
functionality.
Set the maintenance switch to OFF unless the
setting is specified in the operating procedure etc.
When operating the maintenance switch, follow the
procedure in
Chapter 1 (7. Resetting and Clearing
the Server)
in this manual.
If the problem persists, contact your sales
representative.
UEFI
253
IMPORTANT: One or more embedded
PCIe Device(s) are attached to a
non-installed processor and will not
function.
Some built-in devices are not available unless the
processor is added. Add a processor if necessary. If
the problem persists, contact your sales
representative.
UEFI
254
IMPORTANT: The PCIe Device installed
in Slot %1 has no corresponding
processor installed and will not
function.
The optional card is connected to a PCIe slot that is
not available unless a processor is added. Change
the slot which the PCIe expansion card is
connected to, otherwise add a processor. If the
problem persists, contact your sales
representative.
UEFI
261
Server Platform Services Firmware
requires update.
Update the server platform service firmware. If the
problem persists, contact your sales
representative.
UEFI
264
Server Platform Services Firmware in
Recovery Mode. SPS Firmware
Update Switch 12 of the Maintenance
Switch is in the ON position.
Set the maintenance switch SW12 to OFF unless
the setting is specified in the operating procedure
etc.
When operating the maintenance switch, follow the
procedure in
Chapter 1 (7. Resetting and Clearing
the Server)
in this manual.
If the problem persists, contact your sales
representative.
UEFI
266
Non-Volatile Memory Corruption
Detected. Configuration settings
restored to defaults. If enabled, Secure
Boot security settings may be lost.
The system configuration has been initialized to
default. Make the necessary settings in the system
utility. If the problem persists, contact your sales
representative.
UEFI
267
IMPORTANT: Default configuration
settings have been restored at the
request of the user.
The system configuration has been initialized to
default. Make the necessary settings in the system
utility. If the problem persists, contact your sales
representative.